One of the cheapest and most useful materials to beautify your home is fiberglass. Installing fiberglass also easy to insulate the new walls of your home. However, improper fiberglass installation can cause problems. Efficiency will be reduced even up to 25% for just a few small gaps when the fiberglass is not properly installed. So, what are the correct steps to install it?
9 Steps of Fiberglass Installation
Installing fiberglass ducts is a complicated job so to avoid risks after installation you can hire an installation service. However, if you know the basic information and can do it yourself, you can install it without professional help.
Make sure that you have chosen the type of fiberglass and prepared the materials and tools. Installing the fiberglass properly can create a room more energy-efficient, and comfortable and leaves more space.
- Take uncoated fiberglass and install it into the pole point you want. Press just enough, not too hard at that point.
- You can cut the batt longer than needed, the benefit is that the friction will be stronger between each stud. There is no gap. Just use a utility knife to cut the bottom of the fiberglass to the end of the bottom plate.
- On the electrical box, you can differentiate the thickness of the batt, then place approximately half of the total thickness on the back of the electrical box. Repeat this step every time you find an electrical box in the room.
- To make it safe and neat, you can cut half the thickness of the insulation at the top and bottom of the electrical box by folding it. Just press it gently and insert it into the pole.
- Check your AC duct system. If the duct runs vertically down the pole, you can thin the insulation in the middle. The result is two layers that are thinner than the previous normal layer.
- Add just one thin pad to the back of the channel. Smooth out the bearings by pressing them through the rear channel of the AC. Do steps 1 to 5 for all poles that require fiberglass.
- Now you need low-expansion aerosol foam. Fill the entire top of the window as well as the space along the bottom and all parts.
- Place the customized pieces of fiberglass on the floor joists and attach them to the outer wall. Usually, there are two sides to this fiberglass, so make sure to install it correctly. You should lay only the fiberglass with the paper surface facing the indoor side. Be careful upside down. So, do it carefully.
- Finally, cover the entire fiberglass installation without a vapor barrier. You can apply polyethylene to the wall frame with staples or a tacker hammer.
Tips to Install Fiberglass to Your Homes
Even though you can use expert services to install it, there are often some users who choose to install it themselves. Even so, you still need sufficient knowledge about fiberglass, and how it works, including how to make it work efficiently with installation that complies with standards. So, if one day you want to install it yourself, you can pay attention to these tips to get the best results.
- Make careful planning. This is related to wherever fiberglass installation will be applied. You can refer to your house plan. Map out the parts that require fiberglass. Take care to avoid doors, windows, or other structures as much as possible.
- Make a larger hole in the area with the fiberglass channel. A whole saw is the right tool for cutting holes in the floor or ceiling of a house.
- Start installing fiberglass from the end of the route in the mapping until it ends at the other end. Prepare screws and straps every time a channel is installed.
- Air leaks in the holes can be avoided by covering the seams with duct tape or sealant.
- Use insulation to protect fiberglass ducts. Apart from that, it is also valuable for helping to keep the indoor temperature stable.
- Connecting the line to the AC machine must be careful. Because this part is prone to air leaks.
Fiberglass is a good choice to maintaining stable indoor temperature and comfort. However, fiberglass installation should be done correctly and according to standards. Fiberglass’s advantages are saving energy, has many types at more affordable prices, and is also easy to install. You can install it yourself or use the services of experts in this field. Now, it is easy to find many tutorials explaining how to install it simply and correctly.